I am looking to establish the following scenario.
I have two MA's: FIMMA and ADMA
I want to create a Distribution Group through FIM Portal (FIMMA). Also I want to make all the changes to the group only through the AD (NOT through the FIM Portal). I have created both Outbound Sync rules (to push the group to AD upon creation) and Inbound Sync rules (to push the changes to the FIM Portal).
Since I want to make all the changes to a group through AD, I have set ADMA with higher precedence than FIMMA for the Group attributes. This is pushing the group to the AD, but not pushing the attribute values. This happens similarly the other way if I change the precedence. If I set equal precedence, I am able to push the group with all the attributes to the AD, but the changes in the AD is not pushed to the MV.
I am little confused at this point. Is there a way to handle the situation? Any help will be much appreciated.